request dhcp client management-interface release. Step 1: Establish connectivity with the Palo Alto Networks Firewall by connecting an Ethernet cable between the Management and the laptop's Ethernet interface.. By default, when a network port is configured on Palo Alto, it will block access to all services. Below diagram shows the configuration on switch for this. The SonicWall security appliance includes a DHCP (Dynamic Host Configuration Protocol) server to distribute IP addresses, subnet masks, gateway addresses, and DNS server addresses to your network clients. Configure DHCP Server Cisco | ManageEngine Configuration Palo & Cisco. Configure the Management interface as a DHCP client so that it can receive its IP address (IPv4), netmask (IPv4), and default gateway from a DHCP server. How to Configure a Palo Alto Networks Firewall as a DHCP Server In my case, the Palo Alto updated the MAC address to connected devices, except for the loopback interfaces. . By default, the username and password will be admin / admin. Palo Alto Management Interface setup Instruction. PA@Kareemccie.com> run show network interfaces. > Configure # set deviceconfig system ip-address x.x.x.x netmask x.x.x.x default-gateway x.x.x.x # commit CLI Commands for Troubleshooting Palo Alto Firewalls Palo Alto Networks Firewall Management Configuration CLI - firewall.cx First, we need to configure the Syslog Server Profile in Palo Alto Firewall. How to set a route via CLI: To create it, go to Network > Interface Mgmt > click Add and create according to the following information. Step 2.